Charnwood W721 Provozní pokyny Strana 1

12” BANDSAWOPERATING INSTRUCTIONSMODEL: W721Charnwood, Cedar Court, Walker Road, Bardon, Leicestershire, LE67 1TUTel. 01530 516 926 Fax. 01530 516 9

Fit the control handle to the spindle protruding from the side of the saw. Rotate the handle, so that the grubscrew tightens onto the flat side

After ensuring that the quick tension lever is set in the tensioned position, adjust the blade tension with the hand wheel on top of the upper housin

Release the belt tension by turning the tension control handle on the front of the lower housing. Move the belt from the larger pulley to the

Lower the blade guard Remove the rip fence carrier Slide the blade off upper and lower wheels, bringing it out of the mach

838455858687886889909192936786948981824793973389807874197775706968676655656497989941719596504948474615781042434445414033323416151413121151313029282524

W721 Parts List001 Lower door 002 Cap head bolt 003 Spacer bush 004 Lock nut 005 n/a 006 Pilot guide 007 Spring plate 008 Rivet 009 Pilot Pin 010

093 Screw 094 Coach bolt 095 Table 096 Table insert 097 Wing nut 098 End cap 099 Fence bracket 100 Coach bolt 101 Fence 102 Pressure plate 10

GENERAL SAFETY RULES WARNING: Do not attempt to operate the machine until you have thoroughly read and understood completely all instructions, rules

17. Never leave the machine running unattended. Turn the power off. Do not leave the machine until it comes to a complete stop. 18. Do not use any

Specification Table size 550 x 400 mm Table height 1090 mm Motor 750W Blade length 2240 mm Blade widths 6 to 19 mm Blade speeds (no load) Blade

Unpacking Cut the strapping, open the carton and remove all parts from the packaging Assembly Building the stand This is most easily accompl

Fitting the Saw to the Stand If you have someone to help you, the easiest way to join the saw and the stand is to lift the saw and lower it

Screw the longest of the 6 mm hex headed bolts into its hole as shown. Place the table in position on the trunnion and fix it with the four remaini

Screw the four hex, wing bolts and washers into the tapped holes on the underside of the table and slide the rip fence carrier on to them. A

Screw in and lock the push stick hanger. Hang the push stick on it and remember that this is one of the world’s best finger preservers!