Charnwood W730 Provozní pokyny stáhnout pdf (Strana 8)

This pointer is adjustable if the setscrew is

loosened. You may need to make a small

adjustment after the table is set

perpendicular to the blade.

If the table needs to be moved laterally to

centre the slot on the blade, loosen these

three screws, move the table to the correct

position and retighten the bolts.

Screw the four hex, wing bolts and washers

into the tapped holes on the underside of the

table and slide the rip fence carrier on to

them.

Adjust the two hex headed bolts so that the

carrier fits snugly to the table with no gap

between its upper edge and the table.

If you do not keep the carrier tight to the table

the rip fence will not be perpendicular to it.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Komentáře k této Příručce

Žádné komentáře